Edge Trimmer Edged Grinder Floor Grinding Concrete Floor Machine Foldable Arm Corner Processing 220V

Introduction: Floor Grinding and Trimming Machine 220V Note: Give away 5 meters of wires. The maximum length of the machine can be connected to 90 meters of wires. The specification is three-core wires. Each wire should not be less than 6 mm ² of pure copper wire. The wire must be connected to the air switch, and the rated current of the air switch is about 63A. As shown in the picture of wiring mode, please contact us if you have any questions. The input voltage should not be too low. If a generator is used to provide power, the output power of the generator must be at least 7KW. When using, first lift the machine head off the ground,and then turn on the switch. When the machine head rotates normally, gently place it on the ground. When working, the machine head swings left and right, then moves forward, and cannot stop in place. In case of power failure during operation, the switch should be reset and cannot be stopped at the original position to avoid burning the motor when the power is on. Parameters: Voltage: 220V Working Width: 280MM Number of Grinding Head: 3PCS Motor Power: 2.2KW Speed: 1430RPM Weight: 77KG Work Depth: 0-3MM Items Included: 239208-EnzY Floor Grinding and Trimming Machine 220V High performance, stable life, long service life. Power cord without plug. The pure copper motor is of high quality and the product is sturdy and durable. The new statorand rotor of the motor can easily realize the conversion of electrical energy and mechanical energy. Highly adaptable cement floors can also be fully hardened and work can be done at the root of the wall,adjustable position of chassis. Round strong magnetic grinding head, hard, wear-resistant, work efficiency and high quality.